Midland’s quality constructed 2” Energy Saver commercial overhead door is the best 2″ overhead door made. Our 2″ Energy Saver overhead door provides and exceptional R-Value, lasting durability, and a professional look that will last for years to come. Midland’s 2″ Energy Saver is truly the first choice for new construction or retrofit. All of the components that go into our 2″ Energy Saver overhead door, are heavy-duty and built to last.
When you choose a Midland commercial overhead door you can be confident that you have chosen the best overhead door that money can buy!
- 25 gauge rugged exterior and interior steel.
- Efficient polystyrene core resulting in an exceptional R-Value.
- Embossed pebble-grained texture.
- Heavy duty galvanized steel track and hardware.
- Available with many window size design options.
- Available in White, Almond, Sandtone, and Tera-Bronze.
- Available in F/CR Brown, F/CR Hunter Green, F/CR Beige, and our new F/CR Coffee (Fade and Chalk resistant).
Included the doors will be Model 2″ Energy Saver as manufactured by Midland Garage Door Mfg. Co.
- Other Work
Related structure work, opening preparation, field painting and electrical work etc. falls into the responsibility of other trades.
Sections will be roll-formed, hot dipped, galvanized 25 ga. pebble textured exterior and interior. Sections will be pressure bonded to a polystyrene core and will have a thickness of 2″. Sections will incorporate a PVC thermal break to prevent heat or cold conductivity.
Insulation will be rigid 2″ polystyrene free of CFCs and HCFCs and will be laminated to provide strength and prevent loss of thermal efficiency over time. The insulation will have a calculated R-Value of 9.25 U-Value of .10.
- Air Infiltration
All doors will be constructed with a PVC strip and cap between sections to resist air infiltration, and provide a tight fit.
- Wind load
Doors will be designed to meet or exceed industry standards for wind loads (ANSI/ NAGDM 102-1988). Deflection of door in the horizontal position will not exceed 1/120 of the door width. Consult factory for unusual requirements.
- End Stiles
End stiles will be 16 gauge steel and incorporate a thermal break to help prevent heat/cold conductivity between the inside and outside steel skins.
Hinges and fixtures will be galvanized steel. Full floating ball bearing rollers will have hardened steel races. Roller sizes will be adequate for design requirements and limitations.
Track is 2″ or 3″ depending upon door size and requirements. Bracket or angle mounted depending upon door size and requirements.
- Spring Counterbalance
Counterbalance shall be oil tempered, helical wound torsion springs mounted on a ball bearing cross header shaft engineered for industrial application that comply with properties specified by ANSI/NAGDM 102-1988. Galvanized aircraft type lifting cables with minimum safety factor of 8 to 1 and cast aluminum drums are standard.
Lock will be interior mounted slide lock. Optional commercial keyed lock is available.
PVC strip between sections meeting section caps fitted inside every joint. Bottom weather-strip will be U’d shape astragal fastened to the bottom of the door with an extruded aluminum holder for an effective seal at the sill.
Finish will be baked-on polyester over epoxy primer in White interior and 8 exterior color options, (20 GA exterior white only)
Operation will be by manual pull rope. Optional chain hoist and electric operator are available.
Doors should be installed in compliance with Midland Garage Door Mfg. Co. instructions by authorized Midland Garage Door installation professionals.
- Thermal Glazing
- High Cycle Springs
- Jamb Weather-strip
- Electric Operator
- Chain Hoist
- Bottom Sensing Edge
- Rubber Header Seal
- Full Vision Aluminum Sections
- Carwash Modification